Latest FW and latest Slicer but get error due to G-code exporting
Hi all,
I have the latest 5.1.o fw installed and slicer 2.7.0 but when i go to upload and print i get the warning and it fails?
any ideas to fix?
Best Answer by BritX:
Figured this one out finally.. it doesn't like long file names and fails with the BG format error.
shorten your file name when uploading via slicer and http....
RE: Latest FW and latest Slicer but get error due to G-code exporting
You sure you're on 5.1.0 (not 5.0.1)? This is the error you get when the fw is not able to support the bgcode format.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE:
Ha you made me think is it my eyes.. checked
RE: Latest FW and latest Slicer but get error due to G-code exporting
Bump..any help on this?
roll back FW?
RE: Latest FW and latest Slicer but get error due to G-code exporting
Figured this one out finally.. it doesn't like long file names and fails with the BG format error.
shorten your file name when uploading via slicer and http....