Weird first layer but calibration print looks great?
So I followed the Life Adjust Z (yes life) posting on adjusting my Live-Z level and think I got it dialed in. The thickness was measure at 0.213mm with my micrometer. Perfect I thought so I started printing. Here is an album of the layer calibration and my two questionable prints. The second two pictures in the linked album show the first layer and finished bottom of this print, the last picture is of the top layer of this nozzle holder.
These were all printed with CoexNEXT PLA, same PrusaSlicer settings of .2mm Quality. Functionally they came out just fine, but wondering what going on. From reading the bulging of layer lines means I'm too close but then some of that looked like under extrusion.
Ideas?
MINI+ with FW:4.3.3, Bondtech IFS Extruder, drilled out PC4-M8 couplers, 1 piece Capricorn bowden.
RE: Weird first layer but calibration print looks great?
This post from @Bobstro might shed some light on this result: https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/paged/44/#post-568036
Mk3S+,SL1S