Notifications
Clear all

Even with full supports, brig  

  RSS
Ed
 Ed
(@ed)
Active Member
Even with full supports, brig

Hi,

I have an issue with the recessed MicroSD slot in my design. The case is printed with the front on the print bed, so the MicroSD slot is suspended in mid-air with a lot of bridging needed.

I've already disabled "Don't Support Bridges" in PrusaSlicer. This has improved the print a lot, but the "bottom" of the MicroSD slot is still quite bad. Is there anything (in PrusaSlicer, or even in the Fusion360 design) that I could do to improve this?

 

Example of poor bridged layers

Design files and description at https://www.prusaprinters.org/prints/58527-maxduino-case-for-tzxduino-maxduino-board-from-pro

 
This topic was modified 3 years ago by Ed
Posted : 05/03/2021 1:35 pm
Ed
 Ed
(@ed)
Active Member
Topic starter answered:
RE: Even with full supports, bridging a MicroSD card slot produces bad results. Any suggestions?

(sorry, I could not edit topic name anymore)

Posted : 05/03/2021 1:46 pm
Share: