Avisos
Vaciar todo

X axis not responding in test  

  RSS
Jaydenbgrs
(@jaydenbgrs)
New Member
X axis not responding in test

Goodmorning, 

We bought a prusa mini pre essambeled. I put it together without any technical skills by the drawings. probaly i did something wrond but dont know what and where to find. 

Now we have only a technical issue with the Axises, X-Axis and i dont know how to fix this. See pictures. 

Is there in the Netherlands someone that can help us, i'm frustrated that i cannot find the issue. especially for my son, for him is the prusa. 

Can someone contact me by email, [email protected] 

 

Kind regards,

 

Barry Boogers

Respondido : 03/02/2023 7:56 am
karl-herbert
(@karl-herbert)
Illustrious Member
RE: X axis not responding in test

You may find help in your area here: https://world.prusa3d.com/de

Good luck 👍 

wbr,

Karl

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Respondido : 03/02/2023 8:21 am
Hello
(@hello)
Noble Member
RE: X axis not responding in test

Check connection onto board and swap x and y motor round to see if faulty motor 

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Respondido : 03/02/2023 9:14 am
René
(@rene-3)
Reputable Member
RE: X axis not responding in test

In what place do you live?

Read the following instructions completely and at least perform the YZ check.

https://help.prusa3d.com/article/squaring-your-mini_158518

Furthermore, too high belt tension on the X axis can cause this problem.

Decrease the belt tension a little bit.

You can find the instructions here.

https://help.prusa3d.com/article/adjusting-belt-tension-mini_157324

Respondido : 03/02/2023 9:30 am
Compartir: