X axis not responding in test
Goodmorning,
We bought a prusa mini pre essambeled. I put it together without any technical skills by the drawings. probaly i did something wrond but dont know what and where to find.
Now we have only a technical issue with the Axises, X-Axis and i dont know how to fix this. See pictures.
Is there in the Netherlands someone that can help us, i'm frustrated that i cannot find the issue. especially for my son, for him is the prusa.
Can someone contact me by email, [email protected]
Kind regards,
Barry Boogers
RE: X axis not responding in test
You may find help in your area here: https://world.prusa3d.com/de
Good luck 👍
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: X axis not responding in test
Check connection onto board and swap x and y motor round to see if faulty motor
Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models
RE: X axis not responding in test
In what place do you live?
Read the following instructions completely and at least perform the YZ check.
https://help.prusa3d.com/article/squaring-your-mini_158518
Furthermore, too high belt tension on the X axis can cause this problem.
Decrease the belt tension a little bit.
You can find the instructions here.
https://help.prusa3d.com/article/adjusting-belt-tension-mini_157324