First layer separates from steel plate when printing
Hello,
I just assembled my brand new Prusa Mini. I am totally new to 3D printing. I am trying to print the Whistle model in the USB drive that came with it. It starts printing it and prints a first layer and then the plate starts moving a little more rapidly at which point the 1st layer separates from the steel plate and sticks to the nozzle.
How do I solve this? I thought maybe raising the heatbed temperature may help. I raised it from 60 to 66 but still the same thing happened. Please help me fix this.
Thanks,
Milind
RE: First layer separates from steel plate when printing
Hello,
I just assembled my brand new Prusa Mini. I am totally new to 3D printing. I am trying to print the Whistle model in the USB drive that came with it. It starts printing it and prints a first layer and then the plate starts moving a little more rapidly at which point the 1st layer separates from the steel plate and sticks to the nozzle.
How do I solve this? I thought maybe raising the heatbed temperature may help. I raised it from 60 to 66 but still the same thing happened. Please help me fix this.
Thanks,
Milind
Hello and welcome to the Prusaforum!
It's important that the printing bed is clean before you start printing. To clean, use a grease-dissolving detergent, rinse with plenty of water and dry with a lint-free cloth. Then do not touch the printing surface with your fingers. If necessary, wipe with isopropanol.
The First Layer must also be well adjusted. Here is a good explanation:
and here:
https://help.prusa3d.com/en/article/first-layer-calibration_112364
good luck!
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: First layer separates from steel plate when printing
@karl-herbert
Thanks! That worked.
RE: First layer separates from steel plate when printing
@milind-gupta
Great!
Did you carry out both procedures or was the cleaning of the printing bed sufficient?
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: First layer separates from steel plate when printing
I had cleaned it before as well. Did it again. Had to adjust the nozzle offset negative.
RE: First layer separates from steel plate when printing
@milind-gupta
thanks for the feedback and...
happy printing 👍
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.