Prusa3D Forum

Notifications

Clear all

wburkett1965

Groupe: Enregistré

A(ont) rejoint: 2023/08/31

Active Member

	With the results other are getting with the XL thermistor, I... Dans le forum Assembly and first prints troubleshooting	il y a 12 months
	You're not the only one with this problem. Dans le forum Hardware, firmware and software help	il y a 12 months
	No change here with any firmware or PrusaSlicer version. I t... Dans le forum Assembly and first prints troubleshooting	il y a 12 months
	I originally had blue and that needed to either be much high... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	I was thinking the same thing, but no change. I bought a noz... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	If I remember correctly then it has to do with the ramping s... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	I can verify that it is not a drying problem because I have ... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	I am still waiting on my sock to come from China. There is n... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	Today Prusa released the 5.0.0 firmware for the MK4. I had u... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	I have been finding that I have to raise the temps at least ... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	I too am having lots of stinging problems with my new MK4. I... Dans le forum Assembly and first prints troubleshooting	il y a 1 year

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

20 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé