Prusa3D Forum

Notifications

Clear all

wburkett1965

Skupina: Registrovaný

Přidal se: 2023/08/31

Active Member

	With the results other are getting with the XL thermistor, I... In forum Assembly and first prints troubleshooting	před 2 years
	You're not the only one with this problem. In forum Hardware, firmware and software help	před 2 years
	No change here with any firmware or PrusaSlicer version. I t... In forum Assembly and first prints troubleshooting	před 2 years
	I originally had blue and that needed to either be much high... In forum Assembly and first prints troubleshooting	před 2 years
	I was thinking the same thing, but no change. I bought a noz... In forum Assembly and first prints troubleshooting	před 2 years
	If I remember correctly then it has to do with the ramping s... In forum Assembly and first prints troubleshooting	před 2 years
	I can verify that it is not a drying problem because I have ... In forum Assembly and first prints troubleshooting	před 2 years
	I am still waiting on my sock to come from China. There is n... In forum Assembly and first prints troubleshooting	před 2 years
	Today Prusa released the 5.0.0 firmware for the MK4. I had u... In forum Assembly and first prints troubleshooting	před 2 years
	I have been finding that I have to raise the temps at least ... In forum Assembly and first prints troubleshooting	před 2 years
	I too am having lots of stinging problems with my new MK4. I... In forum Assembly and first prints troubleshooting	před 2 years

Fórum Statistiky

585 Fóra

68.3 K Témata

478.1 K Příspěvky

12 Online

76.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed