Prusa3D Forum

Notifications

Clear all

Trax Beaumont

Grupa: Zarejestrowany

Dołączył: 2025/12/17

Active Member

	It's a little bit matte but otherwise it is completely norma... In forum Hardware, firmware and software help	1 day temu
	I apologize if I expressed myself unclearly. I got the print... In forum Hardware, firmware and software help	5 days temu
	After my new filament dryer is now in use, the moisture is a... In forum Hardware, firmware and software help	1 week temu
	A quick update: My new filament dryer should arrive tomorrow... In forum Hardware, firmware and software help	2 weeks temu
	This was PLA and I dried it at about 40°C for around 5 hours... In forum Hardware, firmware and software help	2 weeks temu
	Thank you very much for your ideas and suggestions so far. I... In forum Hardware, firmware and software help	2 weeks temu
	Troubleshooting - looking for ideas In forum Hardware, firmware and software help	2 weeks temu
	Here's a little addition: The camera does not work completel... In forum Buddy3D	2 months temu
	Thank you very much!! That fixed it. I just checked the inst... In forum Buddy3D	2 months temu
	Powering the Buddy3D on a Core One In forum Buddy3D	2 months temu

Statystyki Forum

595 Fora

70.6 K Tematy

494.5 K Posty

15 Online

82 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte