Notifications
Clear all
Trax Beaumont
Skupina: Registrovaný
Přidal se: 2025/12/17
Active Member
1
|
I apologize if I expressed myself unclearly. I got the print... In forum Hardware, firmware and software help |
před 3 days | |
|
After my new filament dryer is now in use, the moisture is a... In forum Hardware, firmware and software help |
před 6 days | |
|
A quick update: My new filament dryer should arrive tomorrow... In forum Hardware, firmware and software help |
před 1 week | |
|
This was PLA and I dried it at about 40°C for around 5 hours... In forum Hardware, firmware and software help |
před 2 weeks | |
|
Thank you very much for your ideas and suggestions so far. I... In forum Hardware, firmware and software help |
před 2 weeks | |
|
Troubleshooting - looking for ideas In forum Hardware, firmware and software help |
před 2 weeks | |
|
Here's a little addition: The camera does not work completel... In forum Buddy3D |
před 2 months | |
|
Thank you very much!! That fixed it. I just checked the inst... In forum Buddy3D |
před 2 months | |
|
Powering the Buddy3D on a Core One In forum Buddy3D |
před 2 months |