Italiano
Forum
Utenti
Thijs
Attività
 
Notifiche
Cancella tutti
Thijs
Thijs
Gruppo: Registrato
Registrato: 2017/05/23
Active Member
1
Profilo Attività
Good tip, I did that and it gave me much improvement! i ha...

Nel forum Prusa i3 kit (Archive)

 8 years fa
I was printing a large print with PETG and it was sticking l...

Nel forum Prusa i3 kit (Archive)

 8 years fa
I am trying to print this pen: This print needs a raft bec...

Nel forum Prusa i3 kit (Archive)

 8 years fa
I have checked the two center bolts and they were a bit loos...

Nel forum Prusa i3 kit (Archive)

 8 years fa
1) Completely reconstructed the extruder carriage and trippl...

Nel forum Prusa i3 kit (Archive)

 8 years fa
How do I control the fan only during calibration? Should I b...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Had that problem, I added 50mm Z lift in OctoPrint after eac...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Thanks for taking the time to help me. At point one I took t...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Calibration Upper left is smooth, strong an...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Messy start.. Almost good, left side is a b...

Nel forum Prusa i3 kit (Archive)

 8 years fa
I understand, I struggle to pinpoint a certain problem so I ...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Unreliable printer

Nel forum Prusa i3 kit (Archive)

 8 years fa
Thanks guys, I think I had the MM Printer settings with the ...

Nel forum Print tips (Archive)

 8 years fa
Thanks for the tip but I seem to have many G1 commands. Is t...

Nel forum Print tips (Archive)

 8 years fa
Firmware upgraded. Slic3r settings updated. Same thing. The ...

Nel forum Print tips (Archive)

 8 years fa
Awesome gcode, finally I feel sure about the Z. Now I just ...

Nel forum Assembly and first prints troubleshooting

 8 years fa
Slic3r big blob

Nel forum Print tips (Archive)

 8 years fa
Slic3r settings

Nel forum Print tips (Archive)

 8 years fa
Condividi: