Deutsch
Foren
Mitglieder
Thijs
Aktivität
 
Benachrichtigungen
Alles löschen
Thijs
Thijs
Gruppe: Registriert
Beigetreten: 2017/05/23
Active Member
1
Profil Aktivität
Good tip, I did that and it gave me much improvement! i ha...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
I was printing a large print with PETG and it was sticking l...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
I am trying to print this pen: This print needs a raft bec...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
I have checked the two center bolts and they were a bit loos...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
1) Completely reconstructed the extruder carriage and trippl...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
How do I control the fan only during calibration? Should I b...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Had that problem, I added 50mm Z lift in OctoPrint after eac...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Thanks for taking the time to help me. At point one I took t...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Calibration Upper left is smooth, strong an...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Messy start.. Almost good, left side is a b...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
I understand, I struggle to pinpoint a certain problem so I ...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Unreliable printer

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Thanks guys, I think I had the MM Printer settings with the ...

Im Forum Print tips (Archive)

 Vor 8 years
Thanks for the tip but I seem to have many G1 commands. Is t...

Im Forum Print tips (Archive)

 Vor 8 years
Firmware upgraded. Slic3r settings updated. Same thing. The ...

Im Forum Print tips (Archive)

 Vor 8 years
Awesome gcode, finally I feel sure about the Z. Now I just ...

Im Forum Assembly and first prints troubleshooting

 Vor 8 years
Slic3r big blob

Im Forum Print tips (Archive)

 Vor 8 years
Slic3r settings

Im Forum Print tips (Archive)

 Vor 8 years
Teilen: