Activité
 
Notifications
Clear all
Thijs
Thijs
Groupe: Enregistré
A(ont) rejoint: 2017/05/23
Active Member
1
Good tip, I did that and it gave me much improvement! i ha...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
I was printing a large print with PETG and it was sticking l...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
I am trying to print this pen: This print needs a raft bec...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
I have checked the two center bolts and they were a bit loos...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
1) Completely reconstructed the extruder carriage and trippl...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
How do I control the fan only during calibration? Should I b...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Had that problem, I added 50mm Z lift in OctoPrint after eac...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Thanks for taking the time to help me. At point one I took t...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Calibration Upper left is smooth, strong an...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Messy start.. Almost good, left side is a b...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
I understand, I struggle to pinpoint a certain problem so I ...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Unreliable printer

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Thanks guys, I think I had the MM Printer settings with the ...

Dans le forum Print tips (Archive)

il y a 7 years
Thanks for the tip but I seem to have many G1 commands. Is t...

Dans le forum Print tips (Archive)

il y a 7 years
Firmware upgraded. Slic3r settings updated. Same thing. The ...

Dans le forum Print tips (Archive)

il y a 7 years
Awesome gcode, finally I feel sure about the Z. Now I just ...

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
Slic3r big blob

Dans le forum Print tips (Archive)

il y a 7 years
Slic3r settings

Dans le forum Print tips (Archive)

il y a 7 years
Partager :