Čeština
Fóra
Uživatelé
Thijs
Aktivita
 
Notifications
Clear all
Thijs
Thijs
Skupina: Registrovaný
Přidal se: 2017/05/23
Active Member
1
Profile Aktivita
Good tip, I did that and it gave me much improvement! i ha...

In forum Prusa i3 kit (Archive)

 před 8 years
I was printing a large print with PETG and it was sticking l...

In forum Prusa i3 kit (Archive)

 před 8 years
I am trying to print this pen: This print needs a raft bec...

In forum Prusa i3 kit (Archive)

 před 8 years
I have checked the two center bolts and they were a bit loos...

In forum Prusa i3 kit (Archive)

 před 8 years
1) Completely reconstructed the extruder carriage and trippl...

In forum Prusa i3 kit (Archive)

 před 8 years
How do I control the fan only during calibration? Should I b...

In forum Prusa i3 kit (Archive)

 před 8 years
Had that problem, I added 50mm Z lift in OctoPrint after eac...

In forum Prusa i3 kit (Archive)

 před 8 years
Thanks for taking the time to help me. At point one I took t...

In forum Prusa i3 kit (Archive)

 před 8 years
Calibration Upper left is smooth, strong an...

In forum Prusa i3 kit (Archive)

 před 8 years
Messy start.. Almost good, left side is a b...

In forum Prusa i3 kit (Archive)

 před 8 years
I understand, I struggle to pinpoint a certain problem so I ...

In forum Prusa i3 kit (Archive)

 před 8 years
Unreliable printer

In forum Prusa i3 kit (Archive)

 před 8 years
Thanks guys, I think I had the MM Printer settings with the ...

In forum Print tips (Archive)

 před 8 years
Thanks for the tip but I seem to have many G1 commands. Is t...

In forum Print tips (Archive)

 před 8 years
Firmware upgraded. Slic3r settings updated. Same thing. The ...

In forum Print tips (Archive)

 před 8 years
Awesome gcode, finally I feel sure about the Z. Now I just ...

In forum Assembly and first prints troubleshooting

 před 8 years
Slic3r big blob

In forum Print tips (Archive)

 před 8 years
Slic3r settings

In forum Print tips (Archive)

 před 8 years
Share: