Prusa3D Forum

Notifications

Clear all

Sascha Uncia

Grupa: Zarejestrowany

Dołączył: 2021/02/17

Active Member

	@joantabb Thanks, I'll try that! In forum PrusaSlicer	4 years temu
	@neophyl Thanks again for the help. Slic3r isn't quite as in... In forum PrusaSlicer	4 years temu
	@joantabb @neophylThank you both. I'm not sure if everything... In forum PrusaSlicer	4 years temu
	@neophyl There is also the Max acceleration when extruding /... In forum PrusaSlicer	4 years temu
	Not sure where the correct places for echo:Accelerations: P=... In forum PrusaSlicer	4 years temu
	SENDING:M503echo:Steps per unit:echo: M92 X80.00 Y80.00 Z800... In forum PrusaSlicer	4 years temu
	@neophyl Wait but what is the difference between the setting... In forum PrusaSlicer	4 years temu
	@neophyl Thanks, I'll try reading eeprom once this benchy is... In forum PrusaSlicer	4 years temu
	@joantabbThat removed a lot of it, there's still some near t... In forum PrusaSlicer	4 years temu
	Example of the clicking, it's drowned out a bit by the fan, ... In forum PrusaSlicer	4 years temu
	Violent shaking on thin infills In forum PrusaSlicer	4 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.5 K Posty

19 Online

69.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte