Prusa3D Forum

Notifications

Clear all

Sascha Uncia

Skupina: Registrovaný

Přidal se: 2021/02/17

Active Member

	@joantabb Thanks, I'll try that! In forum PrusaSlicer	před 4 years
	@neophyl Thanks again for the help. Slic3r isn't quite as in... In forum PrusaSlicer	před 4 years
	@joantabb @neophylThank you both. I'm not sure if everything... In forum PrusaSlicer	před 4 years
	@neophyl There is also the Max acceleration when extruding /... In forum PrusaSlicer	před 4 years
	Not sure where the correct places for echo:Accelerations: P=... In forum PrusaSlicer	před 4 years
	SENDING:M503echo:Steps per unit:echo: M92 X80.00 Y80.00 Z800... In forum PrusaSlicer	před 4 years
	@neophyl Wait but what is the difference between the setting... In forum PrusaSlicer	před 4 years
	@neophyl Thanks, I'll try reading eeprom once this benchy is... In forum PrusaSlicer	před 4 years
	@joantabbThat removed a lot of it, there's still some near t... In forum PrusaSlicer	před 4 years
	Example of the clicking, it's drowned out a bit by the fan, ... In forum PrusaSlicer	před 4 years
	Violent shaking on thin infills In forum PrusaSlicer	před 4 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.5 K Příspěvky

20 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed