Roy – Activité – Prusa3D Forum

Notifications

Clear all

Roy

Groupe: Enregistré

A(ont) rejoint: 2018/02/27

Eminent Member

	Thanks for the link, I will check if there is a similiar rep... Dans le forum Hardware, firmware and software help	il y a 6 years
	Bug? Heaters shutdown after filament change forced by filame... Dans le forum Hardware, firmware and software help	il y a 6 years
	Sounds like the extruder and its PTFE Tube is not aligned co... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Are you printing ABS? This looks like ABS printed on a print... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Pls. also check that your pulleys are tightened. Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	I wanted to give some feedback as I solved my noise problem:... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	I gave it a try and can confirm it is definetely the cover. ... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Thanks for the reply. That was my intention as well. Do you ... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Z-Axis vibrating noise left side Dans le forum Assembly and first prints troubleshooting	il y a 7 years

Page 2 / 2 Précédent

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

20 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé