Roy – Aktivita – Prusa3D Forum

Notifications

Clear all

Roy

Skupina: Registrovaný

Přidal se: 2018/02/27

Eminent Member

	Thanks for the link, I will check if there is a similiar rep... In forum Hardware, firmware and software help	před 6 years
	Bug? Heaters shutdown after filament change forced by filame... In forum Hardware, firmware and software help	před 6 years
	Sounds like the extruder and its PTFE Tube is not aligned co... In forum Assembly and first prints troubleshooting	před 7 years
	Are you printing ABS? This looks like ABS printed on a print... In forum Assembly and first prints troubleshooting	před 7 years
	Pls. also check that your pulleys are tightened. In forum Assembly and first prints troubleshooting	před 7 years
	I wanted to give some feedback as I solved my noise problem:... In forum Assembly and first prints troubleshooting	před 7 years
	I gave it a try and can confirm it is definetely the cover. ... In forum Assembly and first prints troubleshooting	před 7 years
	Thanks for the reply. That was my intention as well. Do you ... In forum Assembly and first prints troubleshooting	před 7 years
	Z-Axis vibrating noise left side In forum Assembly and first prints troubleshooting	před 7 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

559 Fóra

63 K Témata

443.6 K Příspěvky

18 Online

67.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed