Activité
 
Notifications
Clear all
ronyd
ronyd
Groupe: Enregistré
A(ont) rejoint: 2022/12/26
Trusted Member
3
Haven’t found the pdf. Where is it specifically ?

Dans le forum Hardware, firmware and software help

il y a 2 years
Great thankx 👍

Dans le forum Hardware, firmware and software help

il y a 2 years
I check settings and yes, had to set printer to 4mm.

Dans le forum How do I print this? (Printing help)

il y a 2 years
G-Code not same?

Dans le forum How do I print this? (Printing help)

il y a 2 years
Have not yet. Had to replace the hot-end assembly. Running...

Dans le forum Hardware, firmware and software help

il y a 2 years
Corrected issue. Purchased pre-ssembled hot-end from Printed...

Dans le forum Hardware, firmware and software help

il y a 2 years
I assume 2107. Was upgraded from orginal 2.0 to 2.5

Dans le forum Hardware, firmware and software help

il y a 2 years
Msg coming up on the display to do an update 3.10. &nb...

Dans le forum Hardware, firmware and software help

il y a 2 years
oh daaaah.. Sorry MK2.5S thankx Ron

Dans le forum Hardware, firmware and software help

il y a 2 years
Got my E3D 12V Prusa MK2 V6 Hot End Pre Assembled from them...

Dans le forum Hardware, firmware and software help

il y a 2 years
Identify rambo?

Dans le forum Hardware, firmware and software help

il y a 2 years
Aah great that looks better. I’ll give that a try thankx ve...

Dans le forum Hardware, firmware and software help

il y a 2 years
E3D 12V Prusa MK2 V6 Hot End Pre Assembled help needed?

Dans le forum Hardware, firmware and software help

il y a 2 years
Thankx 👌

Dans le forum Assembly and first prints troubleshooting

il y a 2 years
Looks like the thermistor is now shorted. Was going to purch...

Dans le forum Hardware, firmware and software help

il y a 2 years
Perfect thankx 👍

Dans le forum Assembly and first prints troubleshooting

il y a 2 years
Well, cleaned up the filament, heated nozzle temp to 200 deg...

Dans le forum Hardware, firmware and software help

il y a 2 years
oops disregard last post. Thought i had the correct range s...

Dans le forum Hardware, firmware and software help

il y a 2 years
Resistance is open circuit. using High dryer does not chang...

Dans le forum Hardware, firmware and software help

il y a 2 years
aaah i have seen a pic of the board thankx. But egadd, what...

Dans le forum Hardware, firmware and software help

il y a 2 years
Page 4 / 5
Partager :