Activity
 
Notifications
Clear all
ronyd
ronyd
Group: Registered
Joined: 2022/12/26
Trusted Member
3
Haven’t found the pdf. Where is it specifically ?

In forum Hardware, firmware and software help

2 years ago
Great thankx 👍

In forum Hardware, firmware and software help

2 years ago
I check settings and yes, had to set printer to 4mm.

In forum How do I print this? (Printing help)

2 years ago
G-Code not same?

In forum How do I print this? (Printing help)

2 years ago
Have not yet. Had to replace the hot-end assembly. Running...

In forum Hardware, firmware and software help

2 years ago
Corrected issue. Purchased pre-ssembled hot-end from Printed...

In forum Hardware, firmware and software help

2 years ago
I assume 2107. Was upgraded from orginal 2.0 to 2.5

In forum Hardware, firmware and software help

2 years ago
Msg coming up on the display to do an update 3.10. &nb...

In forum Hardware, firmware and software help

2 years ago
oh daaaah.. Sorry MK2.5S thankx Ron

In forum Hardware, firmware and software help

2 years ago
Got my E3D 12V Prusa MK2 V6 Hot End Pre Assembled from them...

In forum Hardware, firmware and software help

2 years ago
Identify rambo?

In forum Hardware, firmware and software help

2 years ago
Aah great that looks better. I’ll give that a try thankx ve...

In forum Hardware, firmware and software help

2 years ago
E3D 12V Prusa MK2 V6 Hot End Pre Assembled help needed?

In forum Hardware, firmware and software help

2 years ago
Thankx 👌

In forum Assembly and first prints troubleshooting

2 years ago
Looks like the thermistor is now shorted. Was going to purch...

In forum Hardware, firmware and software help

2 years ago
Perfect thankx 👍

In forum Assembly and first prints troubleshooting

2 years ago
Well, cleaned up the filament, heated nozzle temp to 200 deg...

In forum Hardware, firmware and software help

2 years ago
oops disregard last post. Thought i had the correct range s...

In forum Hardware, firmware and software help

2 years ago
Resistance is open circuit. using High dryer does not chang...

In forum Hardware, firmware and software help

2 years ago
aaah i have seen a pic of the board thankx. But egadd, what...

In forum Hardware, firmware and software help

2 years ago
Page 4 / 5
Share: