Polski
Fora
Członkowie
Randy
Aktywność
 
Notifications
Clear all
Randy
Randy
Grupa: Zarejestrowany
Dołączył: 2020/06/23
Active Member
1
Profil Aktywność
Thanks @prusatv for sharing your settings. This is super he...

In forum How do I print this? (Printing help)

 4 years temu
as it sounds like you may have a dodgy USB port. Agreed. It...

In forum Hardware, firmware and software help

 4 years temu
Thanks for the replies everyone. I tried a couple of USB st...

In forum Hardware, firmware and software help

 4 years temu
USB sticks not recognized anymore

In forum Hardware, firmware and software help

 4 years temu
Thanks. I've blown the compressed air in the "access panel....

In forum How do I print this? (Printing help)

 4 years temu
Good news: 3dBenchy is printed, short PTFE tube replaced, lo...

In forum How do I print this? (Printing help)

 4 years temu
Thanks everyone for the replies. I finally got my replaceme...

In forum How do I print this? (Printing help)

 4 years temu
Thanks for the help. I upgraded the firmware -- 4.1.0 -- bu...

In forum How do I print this? (Printing help)

 4 years temu
More 💩. My filament won't load now. It just chews up in th...

In forum How do I print this? (Printing help)

 4 years temu
I tried another print with the Filamentum Crystal Clear afte...

In forum How do I print this? (Printing help)

 4 years temu
^^ Also, I'm still on the 4.0.5 firmware and haven't upgrade...

In forum How do I print this? (Printing help)

 4 years temu
Beginner: Consistent problems with Filamentum Crystal Clear ...

In forum How do I print this? (Printing help)

 4 years temu
Mini Firmware Stuck: Change filament -> Calibrate First Laye...

In forum Assembly and first prints troubleshooting

 4 years temu
Share: