Prusa3D Forum

Notifications

Clear all

Randy

Skupina: Registrovaný

Přidal se: 2020/06/23

Active Member

	Thanks @prusatv for sharing your settings. This is super he... In forum How do I print this? (Printing help)	před 4 years
	as it sounds like you may have a dodgy USB port. Agreed. It... In forum Hardware, firmware and software help	před 4 years
	Thanks for the replies everyone. I tried a couple of USB st... In forum Hardware, firmware and software help	před 4 years
	USB sticks not recognized anymore In forum Hardware, firmware and software help	před 4 years
	Thanks. I've blown the compressed air in the "access panel.... In forum How do I print this? (Printing help)	před 4 years
	Good news: 3dBenchy is printed, short PTFE tube replaced, lo... In forum How do I print this? (Printing help)	před 4 years
	Thanks everyone for the replies. I finally got my replaceme... In forum How do I print this? (Printing help)	před 4 years
	Thanks for the help. I upgraded the firmware -- 4.1.0 -- bu... In forum How do I print this? (Printing help)	před 4 years
	More 💩. My filament won't load now. It just chews up in th... In forum How do I print this? (Printing help)	před 4 years
	I tried another print with the Filamentum Crystal Clear afte... In forum How do I print this? (Printing help)	před 4 years
	^^ Also, I'm still on the 4.0.5 firmware and haven't upgrade... In forum How do I print this? (Printing help)	před 4 years
	Beginner: Consistent problems with Filamentum Crystal Clear ... In forum How do I print this? (Printing help)	před 4 years
	Mini Firmware Stuck: Change filament -> Calibrate First Laye... In forum Assembly and first prints troubleshooting	před 5 years

Fórum Statistiky

565 Fóra

63.9 K Témata

447.6 K Příspěvky

19 Online

69.5 K Uživatelé

Poslední Příspěvek: Xl extruder stops Nový Uživatel: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed