Español
Foros
Miembros
Randy
Actividad
 
Avisos
Vaciar todo
Randy
Randy
Grupo: Registrado
Registrado: 2020/06/23
Active Member
1
Perfil Actividad
Thanks @prusatv for sharing your settings. This is super he...

En el foro How do I print this? (Printing help)

 hace 4 years
as it sounds like you may have a dodgy USB port. Agreed. It...

En el foro Hardware, firmware and software help

 hace 4 years
Thanks for the replies everyone. I tried a couple of USB st...

En el foro Hardware, firmware and software help

 hace 4 years
USB sticks not recognized anymore

En el foro Hardware, firmware and software help

 hace 4 years
Thanks. I've blown the compressed air in the "access panel....

En el foro How do I print this? (Printing help)

 hace 4 years
Good news: 3dBenchy is printed, short PTFE tube replaced, lo...

En el foro How do I print this? (Printing help)

 hace 4 years
Thanks everyone for the replies. I finally got my replaceme...

En el foro How do I print this? (Printing help)

 hace 4 years
Thanks for the help. I upgraded the firmware -- 4.1.0 -- bu...

En el foro How do I print this? (Printing help)

 hace 4 years
More 💩. My filament won't load now. It just chews up in th...

En el foro How do I print this? (Printing help)

 hace 4 years
I tried another print with the Filamentum Crystal Clear afte...

En el foro How do I print this? (Printing help)

 hace 4 years
^^ Also, I'm still on the 4.0.5 firmware and haven't upgrade...

En el foro How do I print this? (Printing help)

 hace 4 years
Beginner: Consistent problems with Filamentum Crystal Clear ...

En el foro How do I print this? (Printing help)

 hace 4 years
Mini Firmware Stuck: Change filament -> Calibrate First Laye...

En el foro Assembly and first prints troubleshooting

 hace 5 years
Compartir: