Deutsch
Foren
Mitglieder
Randy
Aktivität
 
Benachrichtigungen
Alles löschen
Randy
Randy
Gruppe: Registriert
Beigetreten: 2020/06/23
Active Member
1
Profil Aktivität
Thanks @prusatv for sharing your settings. This is super he...

Im Forum How do I print this? (Printing help)

 Vor 4 years
as it sounds like you may have a dodgy USB port. Agreed. It...

Im Forum Hardware, firmware and software help

 Vor 4 years
Thanks for the replies everyone. I tried a couple of USB st...

Im Forum Hardware, firmware and software help

 Vor 4 years
USB sticks not recognized anymore

Im Forum Hardware, firmware and software help

 Vor 4 years
Thanks. I've blown the compressed air in the "access panel....

Im Forum How do I print this? (Printing help)

 Vor 4 years
Good news: 3dBenchy is printed, short PTFE tube replaced, lo...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Thanks everyone for the replies. I finally got my replaceme...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Thanks for the help. I upgraded the firmware -- 4.1.0 -- bu...

Im Forum How do I print this? (Printing help)

 Vor 4 years
More 💩. My filament won't load now. It just chews up in th...

Im Forum How do I print this? (Printing help)

 Vor 4 years
I tried another print with the Filamentum Crystal Clear afte...

Im Forum How do I print this? (Printing help)

 Vor 4 years
^^ Also, I'm still on the 4.0.5 firmware and haven't upgrade...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Beginner: Consistent problems with Filamentum Crystal Clear ...

Im Forum How do I print this? (Printing help)

 Vor 4 years
Mini Firmware Stuck: Change filament -> Calibrate First Laye...

Im Forum Assembly and first prints troubleshooting

 Vor 5 years
Teilen: