PrusaTester2020 – Activité

Notifications

Clear all

PrusaTester2020

Groupe: Enregistré

A(ont) rejoint: 2020/08/31

Estimable Member

	It looked like before the nozzle the filament was held or re... Dans le forum PrusaSlicer	il y a 4 years
	Hi! Finally managed to completely fix the problem by putting... Dans le forum PrusaSlicer	il y a 4 years
	Investigation continues. This is a picture from my last prin... Dans le forum PrusaSlicer	il y a 4 years
	Did all that. Prove me I am wrong but if X and/or Y axis wer... Dans le forum PrusaSlicer	il y a 4 years
	@tim-m30 The temperatures of the nozzle during the "bad" zon... Dans le forum PrusaSlicer	il y a 4 years
	I adjusted the belt tension just before the frog print. They... Dans le forum PrusaSlicer	il y a 4 years
	Sorry but the problem appeared today. It seemed it's not onl... Dans le forum PrusaSlicer	il y a 4 years
	FIXED: The solution for this strange problem is in this post... Dans le forum Hardware, firmware and software help	il y a 4 years
	@tim-m30 I tried with 2mm. wall and it was exactly 2mm (chec... Dans le forum PrusaSlicer	il y a 4 years
	Hi! I think I managed to find what causes all my problems. O... Dans le forum PrusaSlicer	il y a 4 years
	Yes, I also think that the nozzle with the fillament is pres... Dans le forum PrusaSlicer	il y a 4 years
	I tried printing using this recommended settings:- lower ret... Dans le forum PrusaSlicer	il y a 4 years
	Would you send me your config or it's confidential? Dans le forum PrusaSlicer	il y a 4 years
	Here is the PrusaSlicer 3MK file attached. Attachment remo... Dans le forum Hardware, firmware and software help	il y a 4 years
	Here is the PrusaSlicer 3MK file attached. Attachment remo... Dans le forum PrusaSlicer	il y a 4 years
	How to set consistent printed layers Dans le forum PrusaSlicer	il y a 4 years
	I went deeper and found that GCode (attached) produced by Pr... Dans le forum Hardware, firmware and software help	il y a 4 years
	Ok, but when at the end you have tall ears or horns of anima... Dans le forum Hardware, firmware and software help	il y a 4 years
	Could not print flawlessly a simple 4x4x36 mm cylinder Dans le forum Hardware, firmware and software help	il y a 4 years
	I contacted the Prusa support and they are sending me two li... Dans le forum Hardware, firmware and software help	il y a 4 years

Page 5 / 6 Précédent Suivant

Statistiques du forum

565 Forums

63.9 K Sujets

447.6 K Messages

23 En-ligne

69.5 K Membres

Le dernier des messages: How do I align Parts? Notre nouveau membre: SilenceDIY Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé