PrusaTester2020 – Aktivität

Benachrichtigungen

Alles löschen

PrusaTester2020

Gruppe: Registriert

Beigetreten: 2020/08/31

Estimable Member

	It looked like before the nozzle the filament was held or re... Im Forum PrusaSlicer	Vor 4 years
	Hi! Finally managed to completely fix the problem by putting... Im Forum PrusaSlicer	Vor 4 years
	Investigation continues. This is a picture from my last prin... Im Forum PrusaSlicer	Vor 4 years
	Did all that. Prove me I am wrong but if X and/or Y axis wer... Im Forum PrusaSlicer	Vor 4 years
	@tim-m30 The temperatures of the nozzle during the "bad" zon... Im Forum PrusaSlicer	Vor 4 years
	I adjusted the belt tension just before the frog print. They... Im Forum PrusaSlicer	Vor 4 years
	Sorry but the problem appeared today. It seemed it's not onl... Im Forum PrusaSlicer	Vor 4 years
	FIXED: The solution for this strange problem is in this post... Im Forum Hardware, firmware and software help	Vor 4 years
	@tim-m30 I tried with 2mm. wall and it was exactly 2mm (chec... Im Forum PrusaSlicer	Vor 4 years
	Hi! I think I managed to find what causes all my problems. O... Im Forum PrusaSlicer	Vor 4 years
	Yes, I also think that the nozzle with the fillament is pres... Im Forum PrusaSlicer	Vor 4 years
	I tried printing using this recommended settings:- lower ret... Im Forum PrusaSlicer	Vor 4 years
	Would you send me your config or it's confidential? Im Forum PrusaSlicer	Vor 4 years
	Here is the PrusaSlicer 3MK file attached. Attachment remo... Im Forum Hardware, firmware and software help	Vor 4 years
	Here is the PrusaSlicer 3MK file attached. Attachment remo... Im Forum PrusaSlicer	Vor 4 years
	How to set consistent printed layers Im Forum PrusaSlicer	Vor 4 years
	I went deeper and found that GCode (attached) produced by Pr... Im Forum Hardware, firmware and software help	Vor 4 years
	Ok, but when at the end you have tall ears or horns of anima... Im Forum Hardware, firmware and software help	Vor 4 years
	Could not print flawlessly a simple 4x4x36 mm cylinder Im Forum Hardware, firmware and software help	Vor 4 years
	I contacted the Prusa support and they are sending me two li... Im Forum Hardware, firmware and software help	Vor 4 years

Seite 5 / 6 Vorherige Nächstes

Forums-Statistiken

565 Foren

63.9 K Themen

447.6 K Beiträge

22 Online

69.5 K Mitglieder

Letzter Beitrag: How do I align Parts? Unser neuestes Mitglied: SilenceDIY Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen