Notifications
Clear all
PrintingFun001
PrintingFun001
Group: Registered
Joined: 2018/03/26
Active Member
1
Support for standard USB webcam?

In forum Introduction & Instructions

4 months ago
Thanks for your thorough response. Hopefully Prusa will acco...

In forum Hardware, firmware and software help

4 months ago
Yes, I've experienced the grinding, but just once. Here is t...

In forum Hardware, firmware and software help

4 months ago
From my reading of the manual on single color/filament print...

In forum How do I print this? (Printing help)

4 months ago
By chance was the filament white? If so, I and another have ...

In forum Hardware, firmware and software help

4 months ago
Same issue. I understand the answers given. Was this a recen...

In forum Hardware, firmware and software help

4 months ago
Which model of printer do you have? The 3.9 and 4.0 have a n...

In forum Hardware, firmware and software help

4 months ago
That is so odd. The exact thing happened to me with a very n...

In forum Hardware, firmware and software help

4 months ago
Thank you for your comments, Diem. The sensor is enabled (al...

In forum Hardware, firmware and software help

10 months ago
Still hoping for some thoughts on this issue. I am concerned...

In forum Hardware, firmware and software help

10 months ago
I hope this is the best spot for this. This month I upgraded...

In forum Hardware, firmware and software help

12 months ago
I seem to have a near identical issue as mithun-m above. I'm...

In forum How do I print this? (Printing help)

5 years ago
Read all these threads, Travis. Virtually identical everythi...

In forum Assembly and first prints troubleshooting

6 years ago
Share: