English
Forums
Members
PJR
Activity
 
Notifications
Clear all
PJR
PJR
Group: Moderator
Joined: 2015/06/01
Title: Antient Member Moderator
Profile Activity
Patrik Do you have the part fan turned on by any chance? T...

In forum Others (Archive)

 9 years ago
Thomas It would be really difficult to detect a thermistor ...

In forum Prusa i3 kit (Archive)

 9 years ago
Then I reverted back to firmware version 3_0_3 and everythin...

In forum Prusa i3 kit (Archive)

 9 years ago
I used NetFabb to do a few cuts and clean up some of the STL...

In forum Awesome prints (Hall Of Fame)

 9 years ago
Yeah, just loaded the model in Slic3r... There is a fault t...

In forum Software (Archive)

 9 years ago
As PR have taken over development of Slic3r (or at least the...

In forum Software (Archive)

 9 years ago
Tim Just realised something else - the sensor you link to r...

In forum Improvements (Archive)

 9 years ago
Kapton tape is available with a width of 200mm. This can be...

In forum Others (Archive)

 9 years ago
Sorry, again I don't know Slic3r, but is this another clue: ...

In forum Others (Archive)

 9 years ago
Kevin He is printing the GCode supplied so the temperature ...

In forum Prusa i3 kit (Archive)

 9 years ago
Richard A new thread would have been a better option as you...

In forum Prusa i3 kit (Archive)

 9 years ago
Kai If your bed is that far out of level, then there will b...

In forum Prusa i3 kit (Archive)

 9 years ago
Download the latest drivers, install everything. Make sure ...

In forum Print tips (Archive)

 9 years ago
When you scale up in the slicer, are there any additional st...

In forum Awesome prints (Hall Of Fame)

 9 years ago
If I slice the model in KISS, the numbers start at layer 12....

In forum Software (Archive)

 9 years ago
That is a really strange one. I had a look at it in KISS (n...

In forum Software (Archive)

 9 years ago
On the Mk1, the PSU (power supply unit) was simply attached ...

In forum Others (Archive)

 9 years ago
Kai Both models have the same first layer height (0.15mm) a...

In forum Prusa i3 kit (Archive)

 9 years ago
Andreas Contact support using the live chat on the shop pag...

In forum Others (Archive)

 9 years ago
Where I work these are called "Unintended Features". Richar...

In forum Others (Archive)

 9 years ago
Page 208 / 281
Share: