Čeština
Fóra
Uživatelé
PJR
Aktivita
 
Notifications
Clear all
PJR
PJR
Skupina: Moderátor
Přidal se: 2015/06/01
Název: Antient Member Moderator
Profile Aktivita
Just make sure you don't get the belts too tight - it is ver...

In forum Others (Archive)

 před 10 years
Patrik Do you have the part fan turned on by any chance? T...

In forum Others (Archive)

 před 10 years
Thomas It would be really difficult to detect a thermistor ...

In forum Prusa i3 kit (Archive)

 před 10 years
Then I reverted back to firmware version 3_0_3 and everythin...

In forum Prusa i3 kit (Archive)

 před 10 years
I used NetFabb to do a few cuts and clean up some of the STL...

In forum Awesome prints (Hall Of Fame)

 před 10 years
Yeah, just loaded the model in Slic3r... There is a fault t...

In forum Software (Archive)

 před 10 years
As PR have taken over development of Slic3r (or at least the...

In forum Software (Archive)

 před 10 years
Tim Just realised something else - the sensor you link to r...

In forum Improvements (Archive)

 před 10 years
Kapton tape is available with a width of 200mm. This can be...

In forum Others (Archive)

 před 10 years
Sorry, again I don't know Slic3r, but is this another clue: ...

In forum Others (Archive)

 před 10 years
Kevin He is printing the GCode supplied so the temperature ...

In forum Prusa i3 kit (Archive)

 před 10 years
Richard A new thread would have been a better option as you...

In forum Prusa i3 kit (Archive)

 před 10 years
Kai If your bed is that far out of level, then there will b...

In forum Prusa i3 kit (Archive)

 před 10 years
Download the latest drivers, install everything. Make sure ...

In forum Print tips (Archive)

 před 10 years
When you scale up in the slicer, are there any additional st...

In forum Awesome prints (Hall Of Fame)

 před 10 years
If I slice the model in KISS, the numbers start at layer 12....

In forum Software (Archive)

 před 10 years
That is a really strange one. I had a look at it in KISS (n...

In forum Software (Archive)

 před 10 years
On the Mk1, the PSU (power supply unit) was simply attached ...

In forum Others (Archive)

 před 10 years
Kai Both models have the same first layer height (0.15mm) a...

In forum Prusa i3 kit (Archive)

 před 10 years
Andreas Contact support using the live chat on the shop pag...

In forum Others (Archive)

 před 10 years
Stránka 208 / 281
Share: