Prusa3D Forum

Notifiche

Cancella tutti

PetesActionFigures

Gruppo: Registrato

Registrato: 2020/12/29

Active Member

	Well, I installed firmware 3.14.1 on my MK3S+. But then I s... Nel forum Hardware, firmware and software help	8 months fa
	I go to "pause print" and then "unload filament"... Nel forum Hardware, firmware and software help	8 months fa
	Does anyone know if this issue was fixed in firmware version... Nel forum Hardware, firmware and software help	8 months fa
	I downgraded to firmware version 3.12.2 and it worked fine a... Nel forum Hardware, firmware and software help	2 years fa
	I have the same issue. Never had this problem before this v... Nel forum Hardware, firmware and software help	2 years fa
	I was feeling frustrated like akerezy, so I did ALL of peter... Nel forum Assembly and first prints troubleshooting	5 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.9 K Post

9 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso