Notifications
Clear all
PetesActionFigures
Groupe: Enregistré
A(ont) rejoint: 2020/12/29
Active Member
1
|
Well, I installed firmware 3.14.1 on my MK3S+. But then I s... Dans le forum Hardware, firmware and software help |
il y a 8 months | |
|
I go to "pause print" and then "unload filament"... Dans le forum Hardware, firmware and software help |
il y a 8 months | |
|
Does anyone know if this issue was fixed in firmware version... Dans le forum Hardware, firmware and software help |
il y a 8 months | |
|
I downgraded to firmware version 3.12.2 and it worked fine a... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
I have the same issue. Never had this problem before this v... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
I was feeling frustrated like akerezy, so I did ALL of peter... Dans le forum Assembly and first prints troubleshooting |
il y a 5 years |