Italiano
Forum
Utenti
pbnj
Attività
 
Notifiche
Cancella tutti
pbnj
pbnj
Gruppo: Registrato
Registrato: 2016/05/15
Trusted Member
3
Profilo Attività
The unit work really well right out of the box. The only thi...

Nel forum Others (Archive)

 10 years fa
In simplify3d would this be the setting under extruder /Ooze...

Nel forum Others (Archive)

 10 years fa
I have two that have been working 24/7 with only very minor ...

Nel forum Others (Archive)

 10 years fa
thanks

Nel forum Others (Archive)

 10 years fa
LIST OF G CODES

Nel forum Others (Archive)

 10 years fa
What is causing the blockage. Keep my finger crossed I have ...

Nel forum Others (Archive)

 10 years fa
Assuming that you have good layers then bad layers, I have s...

Nel forum Others (Archive)

 10 years fa
What exactly is the problem?

Nel forum Others (Archive)

 10 years fa
Lost of bed calibration

Nel forum Others (Archive)

 10 years fa
Also check and make sure that your filament drive gear, the ...

Nel forum Others (Archive)

 10 years fa
I have notice that the more I print the marks seem to be les...

Nel forum Others (Archive)

 10 years fa
.8mm nozzle tips with PLA

Nel forum Others (Archive)

 10 years fa
#1 work on a surface where if you drop a screw you can find ...

Nel forum Others (Archive)

 10 years fa
What slicer are you using. What is the manufactor of the PLA...

Nel forum Others (Archive)

 10 years fa
I too have the same driver and firmware that you are running...

Nel forum Others (Archive)

 10 years fa
Outside finish

Nel forum Others (Archive)

 10 years fa
Did not see this. Spoke with customer service and they advis...

Nel forum Hardware, firmware and software help

 10 years fa
Just gat my second MK2 (Factory assembled) and there were n...

Nel forum Others (Archive)

 10 years fa
ULTEM PEI bed film replacement

Nel forum Hardware, firmware and software help

 10 years fa
The correct software works wonders. Fixed Than ks all.

Nel forum Others (Archive)

 10 years fa
Pagina 4 / 5
Condividi: