Italiano
Forum
Utenti
pbnj
Attività
 
Notifiche
Cancella tutti
pbnj
pbnj
Gruppo: Registrato
Registrato: 2016/05/15
Trusted Member
3
Profilo Attività
The unit work really well right out of the box. The only thi...

Nel forum Others (Archive)

 8 years fa
In simplify3d would this be the setting under extruder /Ooze...

Nel forum Others (Archive)

 8 years fa
I have two that have been working 24/7 with only very minor ...

Nel forum Others (Archive)

 8 years fa
thanks

Nel forum Others (Archive)

 8 years fa
LIST OF G CODES

Nel forum Others (Archive)

 8 years fa
What is causing the blockage. Keep my finger crossed I have ...

Nel forum Others (Archive)

 8 years fa
Assuming that you have good layers then bad layers, I have s...

Nel forum Others (Archive)

 8 years fa
What exactly is the problem?

Nel forum Others (Archive)

 8 years fa
Lost of bed calibration

Nel forum Others (Archive)

 8 years fa
Also check and make sure that your filament drive gear, the ...

Nel forum Others (Archive)

 8 years fa
I have notice that the more I print the marks seem to be les...

Nel forum Others (Archive)

 8 years fa
.8mm nozzle tips with PLA

Nel forum Others (Archive)

 8 years fa
#1 work on a surface where if you drop a screw you can find ...

Nel forum Others (Archive)

 8 years fa
What slicer are you using. What is the manufactor of the PLA...

Nel forum Others (Archive)

 8 years fa
I too have the same driver and firmware that you are running...

Nel forum Others (Archive)

 8 years fa
Outside finish

Nel forum Others (Archive)

 8 years fa
Did not see this. Spoke with customer service and they advis...

Nel forum Hardware, firmware and software help

 8 years fa
Just gat my second MK2 (Factory assembled) and there were n...

Nel forum Others (Archive)

 8 years fa
ULTEM PEI bed film replacement

Nel forum Hardware, firmware and software help

 8 years fa
The correct software works wonders. Fixed Than ks all.

Nel forum Others (Archive)

 8 years fa
Pagina 4 / 5
Condividi: