Čeština
Fóra
Uživatelé
pbnj
Aktivita
 
Notifications
Clear all
pbnj
pbnj
Skupina: Registrovaný
Přidal se: 2016/05/15
Trusted Member
3
Profile Aktivita
The unit work really well right out of the box. The only thi...

In forum Others (Archive)

 před 8 years
In simplify3d would this be the setting under extruder /Ooze...

In forum Others (Archive)

 před 8 years
I have two that have been working 24/7 with only very minor ...

In forum Others (Archive)

 před 8 years
thanks

In forum Others (Archive)

 před 8 years
LIST OF G CODES

In forum Others (Archive)

 před 8 years
What is causing the blockage. Keep my finger crossed I have ...

In forum Others (Archive)

 před 8 years
Assuming that you have good layers then bad layers, I have s...

In forum Others (Archive)

 před 8 years
What exactly is the problem?

In forum Others (Archive)

 před 8 years
Lost of bed calibration

In forum Others (Archive)

 před 8 years
Also check and make sure that your filament drive gear, the ...

In forum Others (Archive)

 před 8 years
I have notice that the more I print the marks seem to be les...

In forum Others (Archive)

 před 8 years
.8mm nozzle tips with PLA

In forum Others (Archive)

 před 8 years
#1 work on a surface where if you drop a screw you can find ...

In forum Others (Archive)

 před 8 years
What slicer are you using. What is the manufactor of the PLA...

In forum Others (Archive)

 před 8 years
I too have the same driver and firmware that you are running...

In forum Others (Archive)

 před 8 years
Outside finish

In forum Others (Archive)

 před 8 years
Did not see this. Spoke with customer service and they advis...

In forum Hardware, firmware and software help

 před 8 years
Just gat my second MK2 (Factory assembled) and there were n...

In forum Others (Archive)

 před 8 years
ULTEM PEI bed film replacement

In forum Hardware, firmware and software help

 před 8 years
The correct software works wonders. Fixed Than ks all.

In forum Others (Archive)

 před 8 years
Stránka 4 / 5
Share: