Notifications
Clear all
Ondrej Kucera
Grupa: PrusaLink-beta
Dołączył: 2022/02/18
Tytuł: Member
| Ideas to improve the user experience | 3 years temu | |
|
It works, thanks. Sorry for the late reply, I didn't have ti... In forum Introduction & Instructions |
3 years temu | |
|
Reinstalling is fine, I'm used to it. Thanks for the advice,... In forum Introduction & Instructions |
3 years temu | |
|
I use 0.6.0-HOTFIX In forum Introduction & Instructions |
3 years temu | |
|
It persists even if the file is less than 2 mb but all are d... In forum Introduction & Instructions |
3 years temu | |
|
Unfortunately, the problem still persists without any change... In forum Introduction & Instructions |
3 years temu | |
|
No g-code previews in Prusaconnect, but it works in Prusalin... In forum Introduction & Instructions |
3 years temu | |
|
OK, thanks In forum PrusaSlicer |
3 years temu | |
|
Nonplanar 3D printing In forum PrusaSlicer |
3 years temu |