Notifiche
Cancella tutti
Ondrej Kucera
Gruppo: PrusaLink-beta
Registrato: 2022/02/18
Titolo: Utenti
| Ideas to improve the user experience | 3 years fa | |
|
It works, thanks. Sorry for the late reply, I didn't have ti... Nel forum Introduction & Instructions |
3 years fa | |
|
Reinstalling is fine, I'm used to it. Thanks for the advice,... Nel forum Introduction & Instructions |
3 years fa | |
|
I use 0.6.0-HOTFIX Nel forum Introduction & Instructions |
3 years fa | |
|
It persists even if the file is less than 2 mb but all are d... Nel forum Introduction & Instructions |
3 years fa | |
|
Unfortunately, the problem still persists without any change... Nel forum Introduction & Instructions |
3 years fa | |
|
No g-code previews in Prusaconnect, but it works in Prusalin... Nel forum Introduction & Instructions |
3 years fa | |
|
OK, thanks Nel forum PrusaSlicer |
4 years fa | |
|
Nonplanar 3D printing Nel forum PrusaSlicer |
4 years fa |