Avisos
Vaciar todo
Ondrej Kucera
Grupo: PrusaLink-beta
Registrado: 2022/02/18
Título: Miembro
|
Ideas to improve the user experience En el foro General discussion & User Experience & Ideas |
hace 2 years | |
|
It works, thanks. Sorry for the late reply, I didn't have ti... En el foro Introduction & Instructions |
hace 2 years | |
|
Reinstalling is fine, I'm used to it. Thanks for the advice,... En el foro Introduction & Instructions |
hace 2 years | |
|
I use 0.6.0-HOTFIX En el foro Introduction & Instructions |
hace 2 years | |
|
It persists even if the file is less than 2 mb but all are d... En el foro Introduction & Instructions |
hace 2 years | |
|
Unfortunately, the problem still persists without any change... En el foro Introduction & Instructions |
hace 2 years | |
|
No g-code previews in Prusaconnect, but it works in Prusalin... En el foro Introduction & Instructions |
hace 2 years | |
|
OK, thanks En el foro PrusaSlicer |
hace 3 years | |
|
Nonplanar 3D printing En el foro PrusaSlicer |
hace 3 years |