Notifications
Clear all
Ondrej Kucera
Groupe: PrusaLink-beta
A(ont) rejoint: 2022/02/18
Titre: Membre
|
Ideas to improve the user experience Dans le forum General discussion & User Experience & Ideas |
il y a 2 years | |
|
It works, thanks. Sorry for the late reply, I didn't have ti... Dans le forum Introduction & Instructions |
il y a 2 years | |
|
Reinstalling is fine, I'm used to it. Thanks for the advice,... Dans le forum Introduction & Instructions |
il y a 2 years | |
|
I use 0.6.0-HOTFIX Dans le forum Introduction & Instructions |
il y a 2 years | |
|
It persists even if the file is less than 2 mb but all are d... Dans le forum Introduction & Instructions |
il y a 2 years | |
|
Unfortunately, the problem still persists without any change... Dans le forum Introduction & Instructions |
il y a 2 years | |
|
No g-code previews in Prusaconnect, but it works in Prusalin... Dans le forum Introduction & Instructions |
il y a 2 years | |
|
OK, thanks Dans le forum PrusaSlicer |
il y a 3 years | |
|
Nonplanar 3D printing Dans le forum PrusaSlicer |
il y a 3 years |