Prusa3D Forum

Notifications

Clear all

Odyssey ventures

Groupe: Enregistré

A(ont) rejoint: 2025/04/30

Active Member

	Also the roll was dried for seven hours @ 65C but it made li... Dans le forum How do I print this? (Printing help)	il y a 4 months
	Haha There are currently two printing in vase mode and they ... Dans le forum How do I print this? (Printing help)	il y a 4 months
	Thank you for the information and ideas Carl. I will play wi... Dans le forum How do I print this? (Printing help)	il y a 4 months
	So I changed the settings to. 20 structural and it worked a ... Dans le forum How do I print this? (Printing help)	il y a 4 months
	I thought that's what I did here. Is this file you need diff... Dans le forum How do I print this? (Printing help)	il y a 4 months
	Ok it is apparently doing the same thing on other filament. ... Dans le forum How do I print this? (Printing help)	il y a 4 months
	What dryer do you use? Dans le forum How do I print this? (Printing help)	il y a 4 months
	Oh. I've been printing their pla and had good luck. It is... Dans le forum How do I print this? (Printing help)	il y a 4 months
	ppv4 My first time doing this...hope it works. I live in ... Dans le forum How do I print this? (Printing help)	il y a 4 months
	print looked perfect until I pulled it off build plate Dans le forum How do I print this? (Printing help)	il y a 4 months

Statistiques du forum

585 Forums

68.1 K Sujets

477.2 K Messages

10 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé