Prusa3D Forum

Notifiche

Cancella tutti

Odyssey ventures

Gruppo: Registrato

Registrato: 2025/04/30

Active Member

	Also the roll was dried for seven hours @ 65C but it made li... Nel forum How do I print this? (Printing help)	4 months fa
	Haha There are currently two printing in vase mode and they ... Nel forum How do I print this? (Printing help)	4 months fa
	Thank you for the information and ideas Carl. I will play wi... Nel forum How do I print this? (Printing help)	4 months fa
	So I changed the settings to. 20 structural and it worked a ... Nel forum How do I print this? (Printing help)	4 months fa
	I thought that's what I did here. Is this file you need diff... Nel forum How do I print this? (Printing help)	4 months fa
	Ok it is apparently doing the same thing on other filament. ... Nel forum How do I print this? (Printing help)	4 months fa
	What dryer do you use? Nel forum How do I print this? (Printing help)	4 months fa
	Oh. I've been printing their pla and had good luck. It is... Nel forum How do I print this? (Printing help)	4 months fa
	ppv4 My first time doing this...hope it works. I live in ... Nel forum How do I print this? (Printing help)	4 months fa
	print looked perfect until I pulled it off build plate Nel forum How do I print this? (Printing help)	4 months fa

Statistiche Forum

585 Forum

68.1 K Discussioni

477.1 K Post

10 Online

75.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso