Prusa3D Forum

Notifications

Clear all

Odyssey ventures

Skupina: Registrovaný

Přidal se: 2025/04/30

Active Member

	Also the roll was dried for seven hours @ 65C but it made li... In forum How do I print this? (Printing help)	před 4 months
	Haha There are currently two printing in vase mode and they ... In forum How do I print this? (Printing help)	před 4 months
	Thank you for the information and ideas Carl. I will play wi... In forum How do I print this? (Printing help)	před 4 months
	So I changed the settings to. 20 structural and it worked a ... In forum How do I print this? (Printing help)	před 4 months
	I thought that's what I did here. Is this file you need diff... In forum How do I print this? (Printing help)	před 4 months
	Ok it is apparently doing the same thing on other filament. ... In forum How do I print this? (Printing help)	před 4 months
	What dryer do you use? In forum How do I print this? (Printing help)	před 4 months
	Oh. I've been printing their pla and had good luck. It is... In forum How do I print this? (Printing help)	před 4 months
	ppv4 My first time doing this...hope it works. I live in ... In forum How do I print this? (Printing help)	před 4 months
	print looked perfect until I pulled it off build plate In forum How do I print this? (Printing help)	před 4 months

Fórum Statistiky

585 Fóra

68.1 K Témata

477.1 K Příspěvky

9 Online

75.7 K Uživatelé

Poslední Příspěvek: edges curl Nový Uživatel: Tommy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed