Italiano
Forum
Utenti
muhendees
Attività
 
Notifiche
Cancella tutti
muhendees
muhendees
Gruppo: Registrato
Registrato: 2023/12/28
Active Member
1
Profilo Attività
What is your Firmware version?

Nel forum Assembly and first prints troubleshooting

 2 years fa
I played around PrusaSlicer a bit and found out you can actu...

Nel forum Input Shaper (MINI)

 2 years fa
Open that gcode file with text editor and scroll to the end....

Nel forum Input Shaper (MINI)

 2 years fa
My bad, confirming that I have this issue as well. Been usin...

Nel forum Hardware, firmware and software help

 2 years fa
This got fixed on Firmware v5.1.2 -->>/p>

Nel forum Hardware, firmware and software help

 2 years fa
are you using IPv6 only? check your IP info -->and see if...

Nel forum General discussion, announcements and releases

 2 years fa
interesting. I have the same issue from day 1. never thought...

Nel forum Assembly and first prints troubleshooting

 2 years fa
I bought my mini as a kit and did few "reassemblies" 😀 I us...

Nel forum Assembly and first prints troubleshooting

 2 years fa
did you print something that was already sliced? I've had th...

Nel forum Assembly and first prints troubleshooting

 2 years fa
Here is how mine looks like inside enclosure. Filament fed f...

Nel forum Hardware, firmware and software help

 2 years fa
If you take a look at all the models on a sheet, they all ha...

Nel forum How do I print this? (Printing help)

 2 years fa
I would do cold-pull and some nozzle clean-up as well. I cha...

Nel forum Input Shaper (MINI)

 2 years fa
I think this might be helpful:/p>

Nel forum Hardware, firmware and software help

 2 years fa
Thank you very much for this update. I usually check belt te...

Nel forum General discussion, announcements and releases

 2 years fa
I usually don't post but this is my first lol. I've purchase...

Nel forum General discussion, announcements and releases

 2 years fa
Condividi: