English
Forums
Members
muhendees
Activity
 
Notifications
Clear all
muhendees
muhendees
Group: Registered
Joined: 2023/12/28
Active Member
1
Profile Activity
What is your Firmware version?

In forum Assembly and first prints troubleshooting

 1 year ago
I played around PrusaSlicer a bit and found out you can actu...

In forum Input Shaper (MINI)

 1 year ago
Open that gcode file with text editor and scroll to the end....

In forum Input Shaper (MINI)

 1 year ago
My bad, confirming that I have this issue as well. Been usin...

In forum Hardware, firmware and software help

 1 year ago
This got fixed on Firmware v5.1.2 -->>/p>

In forum Hardware, firmware and software help

 1 year ago
are you using IPv6 only? check your IP info -->and see if...

In forum General discussion, announcements and releases

 1 year ago
interesting. I have the same issue from day 1. never thought...

In forum Assembly and first prints troubleshooting

 1 year ago
I bought my mini as a kit and did few "reassemblies" 😀 I us...

In forum Assembly and first prints troubleshooting

 1 year ago
did you print something that was already sliced? I've had th...

In forum Assembly and first prints troubleshooting

 1 year ago
Here is how mine looks like inside enclosure. Filament fed f...

In forum Hardware, firmware and software help

 1 year ago
If you take a look at all the models on a sheet, they all ha...

In forum How do I print this? (Printing help)

 1 year ago
I would do cold-pull and some nozzle clean-up as well. I cha...

In forum Input Shaper (MINI)

 1 year ago
I think this might be helpful:/p>

In forum Hardware, firmware and software help

 1 year ago
Thank you very much for this update. I usually check belt te...

In forum General discussion, announcements and releases

 1 year ago
I usually don't post but this is my first lol. I've purchase...

In forum General discussion, announcements and releases

 1 year ago
Share: