Čeština
Fóra
Uživatelé
mixer3d
Aktivita
 
Notifications
Clear all
mixer3d
mixer3d
Skupina: Registrovaný
Přidal se: 2023/10/15
Estimable Member
4
Profile Aktivita
At least on my side i don't have any issues with alpha2, and...

In forum Input Shaper (MINI)

 před 2 years
Hi i just updated to the alpha2 firmware for mini+ and again...

In forum General discussion, announcements and releases

 před 2 years
Hi, i have just updated to the alpha2 firmware, and so far s...

In forum Input Shaper (MINI)

 před 2 years
thank you JoanTabb for tip 🙂

In forum Assembly and first prints troubleshooting

 před 2 years
Hi, yes i realized that in the meantime..., since yesterday ...

In forum Assembly and first prints troubleshooting

 před 2 years
For me the sensor works during print, so will trigger warnin...

In forum Input Shaper (MINI)

 před 2 years
Hi i wanted to update, so i checked around and i found in th...

In forum Input Shaper (MINI)

 před 2 years
here the file sending over WiFi always stops after some 3.6M...

In forum Input Shaper (MINI)

 před 2 years
And finally print with the new setting: so this is the layer...

In forum Assembly and first prints troubleshooting

 před 2 years
Ok, so i did the tests and the outcome was that i had to inc...

In forum Assembly and first prints troubleshooting

 před 2 years
thank you! i will try that, i was wondering about that, if i...

In forum Assembly and first prints troubleshooting

 před 2 years
I found the other topic, check this too:/p>

In forum Assembly and first prints troubleshooting

 před 2 years
Hi, i have the first printer ever, (mini+) since few days, s...

In forum Assembly and first prints troubleshooting

 před 2 years
my first Benchy ever, around 16m Prusa Galaxy Silver

In forum General discussion, announcements and releases

 před 2 years
Stránka 7 / 7
Share: