English
Forums
Members
mixer3d
Activity
 
Notifications
Clear all
mixer3d
mixer3d
Group: Registered
Joined: 2023/10/15
Estimable Member
4
Profile Activity
At least on my side i don't have any issues with alpha2, and...

In forum Input Shaper (MINI)

 2 years ago
Hi i just updated to the alpha2 firmware for mini+ and again...

In forum General discussion, announcements and releases

 2 years ago
Hi, i have just updated to the alpha2 firmware, and so far s...

In forum Input Shaper (MINI)

 2 years ago
thank you JoanTabb for tip 🙂

In forum Assembly and first prints troubleshooting

 2 years ago
Hi, yes i realized that in the meantime..., since yesterday ...

In forum Assembly and first prints troubleshooting

 2 years ago
For me the sensor works during print, so will trigger warnin...

In forum Input Shaper (MINI)

 2 years ago
Hi i wanted to update, so i checked around and i found in th...

In forum Input Shaper (MINI)

 2 years ago
here the file sending over WiFi always stops after some 3.6M...

In forum Input Shaper (MINI)

 2 years ago
And finally print with the new setting: so this is the layer...

In forum Assembly and first prints troubleshooting

 2 years ago
Ok, so i did the tests and the outcome was that i had to inc...

In forum Assembly and first prints troubleshooting

 2 years ago
thank you! i will try that, i was wondering about that, if i...

In forum Assembly and first prints troubleshooting

 2 years ago
I found the other topic, check this too:/p>

In forum Assembly and first prints troubleshooting

 2 years ago
Hi, i have the first printer ever, (mini+) since few days, s...

In forum Assembly and first prints troubleshooting

 2 years ago
my first Benchy ever, around 16m Prusa Galaxy Silver

In forum General discussion, announcements and releases

 2 years ago
Page 7 / 7
Share: