Italiano
Forum
Utenti
mixer3d
Attività
 
Notifiche
Cancella tutti
mixer3d
mixer3d
Gruppo: Registrato
Registrato: 2023/10/15
Estimable Member
4
Profilo Attività
At least on my side i don't have any issues with alpha2, and...

Nel forum Input Shaper (MINI)

 2 years fa
Hi i just updated to the alpha2 firmware for mini+ and again...

Nel forum General discussion, announcements and releases

 2 years fa
Hi, i have just updated to the alpha2 firmware, and so far s...

Nel forum Input Shaper (MINI)

 2 years fa
thank you JoanTabb for tip 🙂

Nel forum Assembly and first prints troubleshooting

 2 years fa
Hi, yes i realized that in the meantime..., since yesterday ...

Nel forum Assembly and first prints troubleshooting

 2 years fa
For me the sensor works during print, so will trigger warnin...

Nel forum Input Shaper (MINI)

 2 years fa
Hi i wanted to update, so i checked around and i found in th...

Nel forum Input Shaper (MINI)

 2 years fa
here the file sending over WiFi always stops after some 3.6M...

Nel forum Input Shaper (MINI)

 2 years fa
And finally print with the new setting: so this is the layer...

Nel forum Assembly and first prints troubleshooting

 2 years fa
Ok, so i did the tests and the outcome was that i had to inc...

Nel forum Assembly and first prints troubleshooting

 2 years fa
thank you! i will try that, i was wondering about that, if i...

Nel forum Assembly and first prints troubleshooting

 2 years fa
I found the other topic, check this too:/p>

Nel forum Assembly and first prints troubleshooting

 2 years fa
Hi, i have the first printer ever, (mini+) since few days, s...

Nel forum Assembly and first prints troubleshooting

 2 years fa
my first Benchy ever, around 16m Prusa Galaxy Silver

Nel forum General discussion, announcements and releases

 2 years fa
Pagina 7 / 7
Condividi: