Prusa3D Forum

Notifications

Clear all

MartinV

Skupina: Registrovaný

Přidal se: 2020/04/11

Active Member

	I'm also interested in reducing stringing and was looking at... In forum PrusaSlicer	před 1 year
	Preset confusion In forum PrusaSlicer	před 1 year
	Getting inside and outside print dimensions accurate In forum PrusaSlicer	před 1 year
	I believe you're not seeing the issue with the raft because ... In forum PrusaSlicer	před 2 years
	Thanks for the reply. I had wondered about changing the min... In forum PrusaSlicer	před 2 years
	Support material interface, inter-layer spacing. Where can I... In forum PrusaSlicer	před 2 years
	PHA prints warping and failing In forum How do I print this? (Printing help)	před 2 years
	This model was a specific example of a more general issue an... In forum How do I print this? (Printing help)	před 2 years
	I had a similar issue, and resolved it by adding a surplus h... In forum How do I print this? (Printing help)	před 2 years
	Supports on vertical surfaces don't have any effect In forum How do I print this? (Printing help)	před 2 years
	@guy-k2 Going by the pictures, those boost circuits have the... In forum Coronavirus (COVID-19)	před 5 years
	I know you replied to Guy, but as I had the same idea as you... In forum Coronavirus (COVID-19)	před 5 years
	Hi Guy, I have been trying to send you a private message sin... In forum Coronavirus (COVID-19)	před 5 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.9 K Příspěvky

9 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed