Prusa3D Forum

Notifications

Clear all

markus aurachtal

Grupa: Zarejestrowany

Dołączył: 2020/12/06

Active Member

	I checked the belt status, and the printer said: X-Axis: 260... In forum Hardware, firmware and software help	3 years temu
	Crash detected and after recovering, the x Axis is shifted 0... In forum Hardware, firmware and software help	3 years temu
	I encounter just the same problem. PRUSA ABS white is extrem... In forum How do I print this? (Printing help)	4 years temu
	upper side on top of the print bed In forum Hardware, firmware and software help	4 years temu
	question was if there is a general offset adjustment for hea... In forum Hardware, firmware and software help	4 years temu
	Heatbed temp is 15 deg lower than what printer says In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.7 K Posty

20 Online

67.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte