Prusa3D Forum

Notifications

Clear all

markus aurachtal

Skupina: Registrovaný

Přidal se: 2020/12/06

Active Member

	I checked the belt status, and the printer said: X-Axis: 260... In forum Hardware, firmware and software help	před 3 years
	Crash detected and after recovering, the x Axis is shifted 0... In forum Hardware, firmware and software help	před 3 years
	I encounter just the same problem. PRUSA ABS white is extrem... In forum How do I print this? (Printing help)	před 4 years
	upper side on top of the print bed In forum Hardware, firmware and software help	před 4 years
	question was if there is a general offset adjustment for hea... In forum Hardware, firmware and software help	před 4 years
	Heatbed temp is 15 deg lower than what printer says In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.5 K Příspěvky

19 Online

69.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed