Avisos
Vaciar todo
markus aurachtal
Grupo: Registrado
Registrado: 2020/12/06
Active Member
1
|
I checked the belt status, and the printer said: X-Axis: 260... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Crash detected and after recovering, the x Axis is shifted 0... En el foro Hardware, firmware and software help |
hace 4 years | |
|
I encounter just the same problem. PRUSA ABS white is extrem... En el foro How do I print this? (Printing help) |
hace 5 years | |
|
upper side on top of the print bed En el foro Hardware, firmware and software help |
hace 5 years | |
|
question was if there is a general offset adjustment for hea... En el foro Hardware, firmware and software help |
hace 5 years | |
|
Heatbed temp is 15 deg lower than what printer says En el foro Hardware, firmware and software help |
hace 5 years |